Britax Baby-Safe Owner's Manual download pdf (Page 12)

Instructions for Installation & Use - Series number: 2030/A/2010

HOW TO INSTALLHOW TO INSTALL

C. Grasp the seat belt tongue from inside the Base, pull

through the Base and pass up through the slot on the

other side. The seat belt may be over or under the

plastic strip at the centre inside the Base.

D. Grasp the seat belt tongue and pull right through the

seat belt path.

E. Engage the seat belt tongue to the buckle.

TightentheseatbelttoholdtheBasermly

against the seat back.

Pull sash portion

of seat belt to

remove slack.

Engage seatbelt

INSTALLING UPPER ANCHORAGE STRAP

A.Locatethechildrestraintanchorttinginthe

car that is directly behind the seat location in

the rear seat you have chosen. Refer to the

car owner’s manual for the location (If there

isnoanchoragettingthenrefertopage38

forinstructionsinaddingananchortting.)

Connect the Upper Anchorage Strap Attachment

Clip to the Anchor Fitting.

Lengthen the strap by pressing the adjuster

button (1) and pull the strap (2) so that the

strap is ready to attach to the Carrier.

THIS UPPER ANCHORAGE STRAP MUST

ALWAYS BE FITTED WHEN THE INFANT

CARRIER IS USED IN THE CAR.

Attachment Clip

Car's Anchor Fitting

Fully press Adjuster Button (1)

while pulling Upper Anchorage

Strap (2) to lengthen.

B. While the Infant Carrier is out of the car, store the upper anchorage strap between the

stabilising bar and the car seat back so that it will be ready for use when the Infant Carrier

is put back in the car.

Always attach hook and remove slack.

C. Iftheseatbeltwillnotstaytight,thentthe3-bargatedbuckletothelap-sashbeltto

prevent loosening. See pages 43 to 44. Rarely are these needed.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 24 25

No comments

Britax Baby-Safe Owner's Manual Page 12