Britax Roundabout User's Guide download pdf (Page 37)



Using the Locking Clip

Install child seat into vehicle using instruction

through step 5 on pages 16-21 for rear-facing,

or pages 22-27 for forward-facing.

NOTE:

Clip is attached and stored on the back

of the seat.

1 Push the child seat firmly into the vehicle

seat while removing all slack first from the

lap portion of the vehicle belt, and then the

shoulder portion of the vehicle belt (Fig. A).

2 Hold the lap and shoulders belts together

just behind the latch plate and unbuckle the

vehicle belt without allowing the belt to slip

(Fig. A).

3 While holding the belts and latch plate,

thread the locking clip onto the seat belt

(Fig. B) and slide it into place near the latch

plate (Fig. C).

4 Buckle the seat belt with the locking clip in

place.

5 Verify that the seat belt is tight and the child

seat is secure.

• The child seat is secure when it cannot be

moved front-to-back or side-to-side more than

1 inch (2.5 cm.) at the belt path. If the child seat

is not secure, repeat the installation process or

use an alternate seating location.

IMPORTANT: Remove the locking clip from the

vehicle seat belt when not used with this child seat,

or the vehicle seat belt will not properly restrain a

passenger.





Locking

Clip

Latch Plate



1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

No comments

Britax Roundabout User's Guide Page 37