IMPORTANT – The child seat can be used with either a lap or a lap and
diagonal seat belt.
The larger the child the more upright the seat must be. To change the position
(if required) slide the support leg out until it engages in the desired position.
To slide the support leg in push the two support leg adjuster buttons and pull
up the support leg (dia 3a). Make sure the support leg is engaged rmly.
Place the child seat rearward facing with the back of the child seat positioned
centrally between the driver and passenger seat.
Extend the footprop fully by pressing the two release Buttons.Make sure
that the footprop tether brackets are facing forwards and that the straps
are not twisted. Lower the footprop and adjust the height so that it is within
approximately 30mm of the oor (dia 3b). Use the ruler printed on the back
page of this manual to get the correct distance from the footprop to the oor.
Loop a tether strap around both the
front driver and passenger seat as
shown (dia 3c).
If your car is equipped with a runner
loop on the seat runners, these may be
used as an alternative (see detail 3d).
IMPORTANT – Do not install the tether
straps using the Luggage loops
3b
3c
3. Installing your child seat (rearward facing) in rear middle seat
3a
3d
Slide the loop ends of the tether straps between the front car seat and back
as shown (dia 2d &
dia 2e). Bring the hook ends of the tether straps
round the outside of the car seat and feed through the loops
2
. Snap
the hooks of the tether straps onto the xing rings on the back of the child
seat
3
. Provisionally tighten the tether straps by pulling the loose ends
downwards
4
.
Open the other lock-off arm , feed the seat belt under the lock-off arm and
attach the tongue into the buckle (dia 3g).
3h
Pull all of the seat belt slack through
the child seat ensuring the seat belt
is not twisted (dia 3h). When the belt
is as tight as possible, close the lock-
off arms on BOTH sides of the seat
ensuring that they click into place.
If the buckle now lies in the position
marked as wrong with a
and the
seat belt cannot be correctly tightened
(dia 3i), try another seating position in
the car.
3i
3g
3f
Pull off sufcient lap and diagonal belt (approx.600 – 900mm). Open the lock-
off arm on the side opposite the seat belt buckle. Pull back the child seat cover
to reveal the crotch strap. Feed the belt through the lock-off belt guide and seat
shell slot (dia 3f) on to the top face of the seat base, behind the crotch strap
(inset) and down through the slot on the other side of the child seat.
Finally tighten the tether straps by pulling the loose ends downwards (dia 3j)
until the footprop touches the oor. The footprop must rest on a solid oor –
not on lids of storage boxes or similar.
Once rmly strapped in, test the child seat by trying to move it back and forth
and side to side. If it seems loose, you must reinstall until rmly installed.
DO NOT rest the back of the child seat against the driver or front passenger
seats.
3j
9-25 kg
3e
2
4
3
(31 pages)
(40 pages)
(45 pages)
(52 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals