Britax ADVOCATE User's Guide download pdf (Page 21)

Slowly pull the adjuster strap 8

until the harness is snug

around the child. The harness

adjuster will click when the

harness is snug.

NOTE: The Click & Safe™ Snug

Harness Indicator is an audible aide

to help determine when the harness

is within range of appropriate

snugness. When tightening the

harness, this audible click provides

extra assurance that the harness is snug.

A snug strap should not allow any slack. •

It lies in a relatively straight line without

sagging. It does not press on the child’s

flesh or push the child’s body into an

unnatural position.

You should not be able to pinch excess •

webbing at the shoulder once the harness

is properly secured.

If there is still slack in the harness, review 9

the checklist and then pull the harness adjuster strap again until

another click indicates a snug harness.

Position the chest clip at the middle of the child’s chest, level with 10

the child’s armpits (Fig. A).

Verify that the harness is not twisted and the child is properly 11

secured.

IMPORTANT: Always pull on the harness after securing the child to

ensure the buckle tongues are secure in the harness buckle.

Cover Removal

Remove the infant body pillow.1

Loosen the harness by lifting the harness 2

adjuster lever while pulling both shoulder

straps forward as far as possible.

Release the chest clip and unbuckle the 3

harness.

Unhook the shoulder straps from the 4

harness yoke on the rear of the child seat

(Fig. B).

Pull the upper harness straps through the 5

head restraint and cover to the front of the

child seat.

Recline the child seat.6

Locate the metal buckle strap retainer on the 7

bottom of the child seat.

Pull the retainer away from the child seat to 8

loosen.

Turn the retainer so the short side will fit through the slot in the child 9

seat shell (Fig. C).

Push the retainer through the slots in the shell and cover, to the top 10

of the child seat.

Remove the head restraint portion of the cover. Remove the energy-11

absorbing foam from the head restraint and set aside.

Be careful not to damage the energy-absorbing foam.*

Gently remove the upper portion of the cover by pulling it from 12

behind the side air cushions and then around the head restraint.

Pull the lower harness straps, buckle tongues, HUGS13

™

chest pads,

and chest clip through the lower slots in cover.

Remove the entire cover from the child seat.14

Pull the harness adjuster away

from the child seat to tighten.

Do not pull sideways.

Securing Your Child Care and Maintenance

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Comments to this Manuals

No comments

Britax ADVOCATE User's Guide Page 21

Comments to this Manuals

Related products and manuals for Car seat Britax ADVOCATE