Britax Hi-Liner SG User Manual download pdf (Page 7)

Pull to remove slack

12 13

HOW TO SETUP

ADJUSTING THE

SLIDEGUARD™CLIP POSITION

A. Adjust the crotch straps for the SLIDEGUARD™clip to

the correct length for your child. It should be kept as low as

possible to keep the lap portion of the seat belt engaged

low-over the hips. Ensure the SLIDEGUARD™clip does not

push into your child's thighs as this may cause discomfort.

B. The crotch strap length adjusters can be found under the

seat. Turn the booster over and adjust as shown.

C. To change the length of the crotch strap, thread through

the adjuster in the direction of the arrows shown.

ALWAYS USE THIS DEVICE.

Lower edge of

SLIDEGUARD™

Clip, level with

top of thighs.

To shorten To lengthen

IMPORTANT :

You must adjust the crotch strap to the correct length for your child before installing the

restraint as it cannot be adjusted in the car.

Always return the crotch strap to its original shorter length when using the seat with a

smaller child. The SLIDEGUARD™clip must always be positioned low down on your child's

body - it will not connect correctly with the seat belt if it is too high. DO NOT attempt to

remove or dismantle the crotch strap.

HOW TO INSTALL

INSTALLING INTO VEHICLE

A. Position the restraint in the car forward facing in the

chosen seating position. Adjust the headrest to the

correct height for your child (refer to page 11). Ensure

the seating position has a child restraint anchorage

tting. Refer to the car owner's handbook. If no tting is

provided refer to anchor tting information on pages 34

to 36.

B. Lengthen the upper anchorage strap by removing the

excess strap from the storage band, then press the

adjuster button (1) and pull the strap with the attachment

clip (2). Hook the attachment clip to the anchor tting.

Make sure to remove any twists from the Upper

Anchorage Strap.

C. Tighten Adjustable Upper Anchorage Strap by pulling

adjusting strap (3) to remove slack. Do not tighten

causing the restraint base to lift off the vehicle seat.

D. Fold up excess strap and use storage band to neatly store

away from child's reach and secure with the hook and

loop storage strap.

Always attach hook and remove slack.

Attachment Clip

Anchor Fitting

Fold up excess

strap and store with

the storage band.

Storage

Band

Storage

Band

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments

Britax Hi-Liner SG User Manual Page 7

Comments to this Manuals

Related products and manuals for Car seat Britax Hi-Liner SG