Britax Max-Way User Manual download pdf (Page 30)

IMPORTANT – The child seat can be used with either a lap or a lap and

diagonal seat belt.

The child seat has an adjustable support leg (dia 2a). The smaller the child the

more reclined the seat must be.

The larger the child the more upright the seat must be. To change the position

(if required) slide the support leg out until it engages in the desired position.

To slide the support leg in push the two support leg adjuster buttons and pull

up the support leg (dia 2b). Make sure the support leg is engaged rmly.

Place the child seat rearward facing on the car seat. After installation the gap

between the seat in front and child seat should be a minimum of 10mm.

It must NOT rest against the car seat. If it does then adjust the car seat in front

without making the driver or passenger sit in an uncomfortable position. If not

try another seating position in the car (dia 2c).

Extend the footprop fully by pressing the two release Buttons. Make sure

that the footprop tether brackets are facing forwards and that the straps

are not twisted. Lower the footprop and adjust the height so that it is within

approximately 30mm of the oor (dia 2c). Use the ruler printed on the back

page of this manual to get the correct distance from the footprop to the oor.

2. Installing your child seat (rearward facing) in rear side seat

Slide the loop ends of the tether straps

between the front car seat and back as

shown (dia 2d &

dia 2e). Bring the

hook ends of the tether straps around

the outside of the car seat and feed

through the loops

. Snap the hooks

of the tether straps onto the xing rings

on the back of the child seat

Provisionally tighten the tether straps by

pulling the loose ends downwards

Pull off sufcient lap and diagonal belt (approx.600 – 900mm). Open the lock-

off arm on the side opposite the seat belt buckle. Pull back the child seat cover

to reveal the crotch strap. Feed the belt through the lock-off belt guide and seat

shell slot (dia 2g), up on to the top face of the seat base, behind the crotch

strap (inset) and down through the slot on the other side of the child seat.

Open the other lock-off arm, feed the seat belt under the lock-off arm and

attach the tongue into the buckle (dia 2h).

Slide the loop ends of the tether straps between the front car seat and back

as shown (dia 2d &

dia 2e). Bring the buckle ends of the tether straps

around the outside of the car seat and feed through the loops

. Click the

snap hooks of the tether straps into the metal loops on back of the seat.

Provisionally tighten the tether straps by pulling the loose ends downwards.

Pull all of the seat belt slack through the

child seat ensuring the seat belt is not

twisted (dia 2i). When the belt is as tight

as possible, close the lock-off arms on

BOTH sides of the seat ensuring that they

click into place.

If the buckle now lies in the position

marked as wrong with a

and the seat

belt cannot be correctly tightened (dia 2j),

try another seating position in the car.

Finally tighten the tether straps by pulling

the loose ends downwards (dia 2k)

until the footprop touches the oor. The

footprop must rest on a solid oor – not

on lids of storage boxes or similar.

Once rmly strapped in, test the child seat

by trying to move it back and forth and

side to side. If it seems loose, you must

reinstall until rmly installed.

DO NOT rest the back of the child seat

against the driver or front passenger

seats.

9-25 kg

1 2 ... 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments

Britax Max-Way User Manual Page 30

Comments to this Manuals

Related products and manuals for Car seat Britax Max-Way