Roundabout® User GuidePLEASE READINSTRUCTIONSSTORE UNDERCOVER
1617Lift the child seat cover and open rear-facing 2 lock-off farthest from where the vehicle belt will be buckled (Fig. B).Pull the vehicle belt out
1819If stored, remove LATCH connectors from 1 storage slots under cover. See page 30.NOTE: Britax child seats are shipped with the LATCH connectors in
2021IMPORTANT: Britax recommends that the Versa-Tether be used at all times. Using the tether will improve the stability of the child seat and reduce
2223IMPORTANT: Britax recommends that the Versa-Tether be used at all times. Using the tether will improve the stability of the child seat and reduce
2425Aircraft InstallationThis child seat is certified for aircraft use. Most airlines in the U.S. and Canada will allow use of a child seat as long as
2627Using the Versa-TetherConsult your vehicle owner’s manual for 1 approved tether-anchorage locations.Locate the tether on the rear of the child 2 s
2829Figure A shows the tether when the child seat is acceptable for continued use (provided the child seat has not been involved in a crash). The colo
3031Storing the LATCH Connectors When the LATCH connectors are not in use, lift the child seat cover to access LATCH storage slots (Fig. A). Fold ea
3233Adjusting the Harness Slot HeightIMPORTANT: See Important Harness Adjustments on pages 6 – 7 for instructions on proper harness fit based on your
3435Child Seat Cover Removal Refitting the CoverTo refit the cover, reverse the previous directions. Make sure the shoulder straps are properly thread
©2008 Britax Child Safety, Inc. All rights reserved. Printed in USA P327600_R1:12.08This product and its components are subject to change without noti
3637Harness Buckle Removal Fully recline the child seat.1 Locate the metal buckle strap retainer on the 2 bottom of the child seat.Pull the retainer a
3839This child seat was manufactured by Britax Child Safety, Inc. Britax® warrants this product to the original retail purchaser as follows:LIMITED ON
Double Check Car Seat-to-Vehicle Installation:Check that the LATCH or vehicle seat belts connections to the vehicle are tight and locked.Verify th
23Use only with children who weigh between 5 and 40 pounds (2.3 and •18.1 kg.) and whose height is 40 inches (101.6 cm.) or less. Use rear-facing for
45Important NotesVerify that the child seat is secure and the harness is properly •adjusted around the child each time the child seat is used.Adjust
67Important Harness AdjustmentsAccording to the American Academy of Pediatrics: All infants should ride rear-facing until they have reached at least
89Cover1 Serial Number and Manufactured 2 Date (Under Cover) Shell3 Forward-Facing Lock-Off4 Forward-Facing Belt Path5 Rear-Facing Belt Path6 Rear-Fac
1011Vehicle Safety BeltsNOTE: The information in this section only applies to installation with vehicle safety belts.IMPORTANT: Vehicle seats and safe
1213LATCH InstallationFigure A illustrates a typical rear-facing LATCH •installation.Verify that your vehicle is equipped with LATCH •anchors. If LA
1415ALift the child seat cover and open the 2 rear-facing lock-off farthest from where the vehicle belt will be buckled (Fig. B).Pull the vehicle belt
Comments to this Manuals