Britax STARRISER COMFY Owner's Manual download pdf (Page 37)

This page will help you to recognize the different parts of your Infant

Restraint.

Shoulder Belt

Adjuster

/ I

Trim Lane1

II’

Base Stabilizer

Foot

Shoulder Height

To ensure that the baby is

properly held in the lnfani

Restraint, the height of the

shoulder straps (1) can be

adjusted to the size of the

child by making use of the

appropriate pair of belt slot5

(Za/2b). To change slots

open the trim panel b)

pulling on the cover latch

Remove chest clip from

shoulder straps by pulling out of slot in front of clip. Pull the shoulder

straps out and reinstall through the other pair of slots. Reclose the

trim panel. Reinstall chest clip.

Belt Tension

To adjust harness tension, open the trim panel by pulling on the

cover latch. To tighten, pull the narrow adjusting strap (3) until the

shoulder straps fit the child’s body snugly. To loosen, press the

button (4) in the belt adjuster and pull on the shoulder straps.

Positioning

Your baby’s back and bottom must rest against the Infant Restraint

without spaces or gaps. Very small babies should be supported at

the sides with rolled-up towels or blankets, never under the baby

Belts And Suckle

I -1l----l

Join both buckle tongues

(5) together and then firmly

insert both tongues

simultaneously into the

buckle (6) so that they lock

with a click. If the tongues

cannot be inserted, press

the release button (7) and

reinsert.

SNUGLY ADJUST THE BELTS PROVIDED WITH THIS CHILD

RESTRAINT AROUND YOUR CHILD.

IMPORTANT: Now pull on the shoulder straps where they buckle

(6) to make sure they are securely fastened.

Chest Clip

Connect the belt

positioning chest clip.

Gently slide the clip up until

the shoulder belts cannot

fall off the baby’s shoulders.

Make sure that the chest

clip is positioned so that it

keeps the shoulder straps

on the infant’s shoulders. If

the chest clip is too wide

for a small infant,

temporarily remove the chest clip until the infant has grown and

reinstall when the chest clip correctly positions the shoulder straps

on the shoulders.

This Infant Restraint performs better with a lap-shoulder belt than

with a lap belt alone.

There are several types of safety belts that will not work with the

Infant Restraint and must NOT be used:

Front seat belts with anchorages (top or bottom) in the door.

Motor-driven automatic belts of any kind.

Three-point lap-shoulder belts that have retractors for the shoulder

section and the lap section. Such belts have latch plates (tongues]

sewn both to the shoulder and the lap sections.

Non-locking (ELR) two-point lap belts.

Your vehicle owner’s manual will have Information on the types of

seat belts in your vehicle. If you have belts of the above listed types,

select another seating position. When using the middle rear seat lap

belt, make sure that the buckle does not catch on the Infant Restraint

frame.

Mercedes-Benz Infant Restraint page 2 of 6

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Comments to this Manuals

No comments

Britax STARRISER COMFY Owner's Manual Page 37

Comments to this Manuals

Related products and manuals for Car seat Britax STARRISER COMFY