Britax STARRISER COMFY Owner's Manual download pdf (Page 49)

Using the Porsche Baby-Safe

When used properly, the Porsche Baby-Safe is desi

,f to safely transport your infant both inside and outs!

ned as a way

e the car. The

safety harness of the Porsche Baby-Safe must be correctly fastened

around the infant (see “Securing your infant in the Porsche Baby-

Safe”).

PORSCHE

Baby-Safe”

Rear Facing Infant Restraint & Carrier

For Children From 5 Ibs - 20 Ibs

Britax Model 401-U

Includes Ajrbag Disconnection Bek For Porsches

Porsche Baby-Safe

Instructions on installation and use

Please read through these instructions carefully before using the

Porsche Babv-Safe. The Porsche Babv-Safe is suitable for infants up

to approximate1 9 months of a e or weighing from 5 Ibs. up to

approximately 2 8 Ibs. (9 kg). Chil f ren larger than this should use the

appropriate chrld or booster seat.

WARNING!

It is possible to secure the Porsche Baby-Safe in the car

incorrectly. This could cause severe injury or death if there

is an accident. Therefore please read through the following

information carefully and make sure that:

the safetv harnesses of the Porsche Babv-Safe always fit

snugly -

the Porsche Baby-Safe is secured with the vehicle seat

belts as described in the instructions.

the disconnection belt ton ue is inserted in the disconnection

belt buckle in front of the % orsche front passenger seat to

turn off the front passenger airbag.

The Porsche Baby-Safe must be used in the Porsche only on the

front passen er seat moved to its rearmost

position, an %

er seat, with the passen

fastened with the lap-s % oulder (3.point) vehicle seat

belt.

Under no circumstances should the Porsche Baby-Safe

be fastened with only a lap (Epoint) belt. The Porsche Baby-

Safe may be used on the front passenger seat in a Porsche

with an airbag (fi

tongue on the If

. X), only if the air bag disconnection belt

orsche Baby-Safe is inserted into the

disconnection buckle in front of the front passenger seat.

Thus

adapter devrce must be installed by an authorized Porsche dealer

when purchasrng the Porsche Baby-Safe. If

belt wrth an automatic lockrng retractor ( K

our vehicle has a seat

LR) see your Owner’s

Manual to enga e It to help prevent unwanted movement of the seat

during normal cf rrvrng.

Further information on this can be found in the car Owner’s

Manual under “Child Restraint Systems and Airbag Systems”.

The Porsche Baby-Safe has two positions, a rigid position (fig. I) and

a rocking position (fig. II).

In the vehicle, the Porsche Baby-Safe

must only be usedIn the rigid position.

Ensure that the supports

(fig. I, 3a and 3b) are always locked in the extended posrtion.

The carryin handle attached to the Porsche Bab

-Safe (fig. Ill, 1)

engages rn t ree positions (A, B, C). Position A or f!

should be used

in the car so that the carrying handle does not interfere with the

shoulder portion of the car belt. The two push buttons (fig. ill, 2)

must be pressed at the same time to adjust the carrying handle to

a different position. Ensure that the carrying handle engages positively

after each adjustment.

Warning:

Be sure that your infant is buckled in and the carry handle

is “locked” before lifting or carrying the child.

Securing your infant in the Porsche Baby-Safe

Place the infant in the Porsche Baby-Safe and fasten the safety

harness securely. Very small infants can be supported with some

kind of padding (cushion) on each side, never underneath.

Adjusting the height of the safety harness shoulder belts

To ensure the infant is held securely in the Porsche Baby-Safe, the

hei ht of the shoulder belts (fig. IV, 8) can be adjusted to the size

of t e child by using the appropriate set of seat belt slots (fig. IV, %

9a or 9b). We recommend selecting the lower set of slots (fig. IV,

9b) for small infants.

To change the set of slots, the cover (fig. IV, 4) must be opened by

pulling on the clas

tongues (fig. V, 1

(fig. IV, 5). The shoulder belts together with the

1 can now be pulled out of the slots and guided

into the other set of slots. Make sure the belt webbing is not twisted.

Fastening the belt buckle

The belt buckle (fig. V, 11) is fastened by inserting the two tongues

(fig. V, 10) together and then insertrng them In the belt buck!e (fig.

V, 10) until you hear them engage (“CLICK”). If they won’t insert,

press the red pushbutton all the way down, then Insert the two

tongues together.

Adjusting the length of the safety harness

Open the cover (fig. IV, 4) by pullrng on the clasp (fig. IV, 5).

To tighten:

Pull upwards on the narrow adjusting belt (fig. IV,

6) towards the top ed e of the seat back, untrl the

shoulder belts (frg. IV, i ) frt snugly across the child’s

body.

To loosen:

To loosen the shoulder belts (fi

IV, 81, press the

button (fig. IV, 7) on the belt a juster and pull on

the shoulder belts. Release the button once the

belts are loose.

Securing the Porsche Baby-Safe in the car

What to do:

a) Make sure the vehicle seat is moved fully to the rear away

from the Instrument panel. Put the Porsche Baby-Safe into

the rrgrd posrtron by folding down the front and rear supports

(fig. 1, 3a and 3b). Place the Porsche Baby-Safe on the car

seat facing the rear of the car. In certain cases the front

support (fig. I, 3b) of the Porsche Baby-Safe may not lie flat

on the surface of the car seat. Placing a rolled towel or

blanket underneath one support may Improve the stabrlity

of the seat.

Porsche Baby-SafeTM Rear Facing Infant Restraint and Carrier page 1 of 3

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments

Britax STARRISER COMFY Owner's Manual Page 49

Comments to this Manuals

Related products and manuals for Car seat Britax STARRISER COMFY