Britax MARATHON 65 User's Guide download pdf (Page 16)

Lap-Shoulder Belt Installation

Figure A illustrates a typical rear-facing, lap-shoulder •

belt installation.

When not in use, always store the LUAS connectors •

in the storage slots. See page 30.

Fully recline the child seat then place it rear-1

facing on the vehicle seat.

Lift the cover to open the rear-facing lock-2

off farthest from where the vehicle belt will

be buckled (Fig. B).

Pull the vehicle belt out, then pass it through 3

the rear-facing belt slot (Fig. C).

The vehicle belt can be routed over or under cover.•

Route the vehicle belt across seat then 4

through the opposite rear-facing belt slot.

IMPORTANT: The vehicle belt must rest behind the

child seat buckle.

Verify that the vehicle belt is not twisted, then 5

buckle (Fig. D).

Push the child seat ﬁrmly into the vehicle 6

seat while removing slack ﬁrst from the lap

portion of the vehicle belt, then the shoulder

portion (Fig. E).

Position both sections of the vehicle belt 7

through the open lock-off, tighten belt, close the lock-off arm

(Fig. F) and replace the cover.

Rear-Facing

Installation: Rear-Facing

WARNING!

This child seat must be reclined

when used rear-facing. See Recline Adjustment on

page 30.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 85 86

No comments

Britax MARATHON 65 User's Guide Page 16