Britax MARATHON 65 User's Guide download pdf (Page 21)

Installation: Forward-Facing

A positive click is NOT heard when the LUAS •

connector and the LUAS anchor are connected.

NOTE: If a positive click is not heard, but the

LUAS connector is in an upright position, you

should not switch the LUAS connectors. The

strap may be too tight or twisted, or there may

be debris in the LUAS connector.

Rotate the child seat into the forward-facing 6

position. Ensure the bottom of the child seat

is in full contact with the vehicle seat.

Verify that the LUAS strap is not twisted, 7

then attach the remaining LUAS connector

to the adjacent LUAS anchor (Fig. D).

A positive click conﬁrms attachment.8

Push the child seat into the vehicle seat while 9

pulling each LUAS strap tight (Fig. E).

Attach the Versa Tether10

hook to the vehicle’s designated tether

anchor. Remove all slack from the tether to secure. Store excess

webbing in the tether pouch. See pages 25–28.

Verify that all connections are secure and that the child seat is 11

stable.

The child seat is secure when it cannot be moved front- to-back or side-•

to-side more than 2.5 cm (1 in.) at the belt path. If the child seat is not

secure, repeat this procedure or use an alternate seating location.

WARNING! Refer to your vehicle owner’s manual or contact the

vehicle manufacturer for the maximum weight rating for their LUAS

anchors. Use vehicle belt (not LUAS connectors) for installations with

children who weigh more than the vehicle LUAS anchor limit. Unless

speciﬁed otherwise by the vehicle manufacturer, assume a 18.1 kg (40

lbs.) child is the vehicle LUAS anchor limit.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 85 86

No comments

Britax MARATHON 65 User's Guide Page 21