Britax MARATHON 65 User's Guide download pdf (Page 14)

Lower Universal Anchorage System (LUAS) Installation

Figure A illustrates a typical rear-facing LUAS

installation.

Verify that your vehicle is equipped with LUAS •

anchors. If LUAS anchors are not available, you

must use the vehicle belt installation methods.

IMPORTANT: LUAS connectors must be in an upright

position (as shown in ﬁgure B) and the strap should be

tight and not twisted to ensure proper installation.

If stored, remove the LUAS connectors from 1

the storage slots under the cover. See page

30.

Press and hold the ﬁrst LUAS adjuster button, 2

then pull the LUAS strap to full length. Repeat

for the remaining LUAS connector.

Fully recline the child seat and place it sideways 3

on the vehicle seat with the front facing you.

Verify the LUAS strap is not twisted, then 4

attach the closest LUAS connector to the

vehicle seat back to the farthest LUAS anchor from you (Fig. C).

NOTE:

It may be necessary to switch the LUAS connectors (pg. 29) if

ANY of the following conditions exist:

LUAS connector is not in an upright position (Fig. B).•

LUAS strap is twisted. •

A positive click is NOT heard when the LUAS connector and LUAS anchor •

are connected.

NOTE: If a positive click is not heard, but the LUAS connector is in an

upright position, you should not switch the LUAS connector. The strap

Installation: Rear-Facing

Rear-Facing

Release

Button

Top

WARNING!

This child seat must be reclined

when used rear-facing. See Recline Adjustment on

page 30.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 85 86

No comments

Britax MARATHON 65 User's Guide Page 14